Atlas Engineering

• Endless belt feeder
• Shaft-mounted gear motor for minimum maintenance
• Individual-frequency control with variable feeding of material monitored and controlled remotely from the control cabin
• Speed vibrator motor is operated by a no-flow switch to ensure continuous material flow for the sands the bin
• Working platform along hoppers

Dryer Drum

• The drum is fitted with a single piece, a hot-formed ring without welded joint (drum tire) on each end, mounted to the drum shell with spring plates
• Each drum tire is seated and rolled on two Trunnion rollers
• Feeding end of the inclined drum is further guided by 2 guide rollers to limit the axial movement
• Special shovel flights are installed to the internal surface along the drum length to transport and form efficient drying curtain to minimize fuel consumption
• Special vacuum drum pressure device is fitted to control rotary actuator at the exhaust fan to regulate the air flow
• Hot mineral bins and screens are dust-tight enclosed

Burner C/W Blower

• Fuel piping system, transfer pump and high-pressure pump are included
• Automatic controls for the burner are included to regulate the capacity based on the temperature monitor by a sensor at the drum exhaust gas outlet
• Fully automatic, electrical ignition by propane gas
• A flame-failure indication that is detected by photocell
• Auto start-up of burner system for maximum safety
• Fuel Pump and Accessories include
• Fuel pump (placed next to the Fuel tank and at ground level)
• Piping to the main burner is inclusive of valve and strainer. Pressure-holding valve ensures the line pressure of fuel reaches high-pressure pump of the burner.
• From outlet of pressure holding valve, a long flexible hose is connected to the inlet filter of the main burner. Flexible hose ensures fast attachment. Inlet filter is mounted

Hot Mineral Bins

• Each compartment is equipped with mechanical overflow chute and sampling pods
• Mineral temperature sensors are located inside the sand compartment
• Oversize material will flow out via overflow chute to a collection point
• Each compartment is equipped with a pneumatically actuated two-stage discharge gates controlled by the computer system.
• Each compartment has a maximum level indicator that is wired remotely to the control room to warn the operator when bins are full

Aggregate Weigher

• Designed to weigh up to 4 different aggregates
• Weigher is fitted with a proper shockproof device to prevent the transmission of vibrations to the load cells
• Discharge of the weigher is through two discharge gates that operated pneumatically.

Filler Weigher

• Designed to weigh up to 3 different sources
• Sealed with neoprene, which is heat resistant in the temperature range of -40 to 150 degree C
• Butterfly valves c/w high torque pneumatic actuator, solenoid valves micro switches

Bitumen Weigher

• Designed to weigh up to 3 different sources
• Bitumen is circulated from the storage tank through 2-way valve, actuated by compressed air
• Weigher tank is insulated with Rockwool slabs and heated at the base by thermal oil
• Weigher is provided with overfilling protection
• Mechanical dial thermometer indicates the bitumen temperature in the tank
• Gravity discharge to bitumen spray pipe

Twin-Shaft Pugmill Mixer

• Direct gear-motor drive with transmission through the synchronous, helical spur gear
• Robust and rugged design to suit hardest site condition.

Additional Information:

• Delivery Time: 30 DAYS
• Packaging Details: LOSS